Elite Remaps



Dynocom AWD 5000 chassis dynamometer


Perfect for diagnosis and performance testing
  • Rear wheel drive
  • Front wheel drive
  • 4WD/AWD cars, recreational vehicles
  • 2WD/4WD race cars
  • Sport utility vehicles
  • Light commercial vehicles
  • Recreational vehicles
  • Motorcycles
  • Full specifications at www.dynocom.eu
Horsepower Testing


Our Dynocom all wheel drive chassis dynamometer measures engine power via the driven wheels in an accurate method and is capable of up to 2600HP!  When you have doubts about the performance of your engine then we can offer you an exact figure of power and torque from a session on our dyno,  even if you plan to tune the vehicle or not,  if you take advantage of an Elite Remaps tune then we can tell you the difference before and after the tuning.

All these details and live data can be printed in full colour for you to save in your records.


Dyno Tuning


Elite Remaps offer a full dyno tuning and setup service so your vehicle can perform to its maximum potential throughout the RPM range.

This way you can be totally 100% sure of the gains provided by our tuning before and after our intervention.  By our multi-parameter Data-Logging systems,  and wide-band air/fuel meter our technicians will have complete access to important information during your vehicles tuning so we can extract the best possible power and maintain safe operating conditions for your engine.


Diagnostic Testing


Elite Remaps can perform tests on our dyno to try and solve or identify engine performance problems,  with the combinations of power and torque measurements and live data collected while running we are able in most cases to identify or make suggestions of the engine component that is not working correctly,  if we measure a lower than expected output in power/torque and we see any value lower than normal (injection,  air mass,  air pressure,  ignition,  etc).

The dyno is the ultimate tool for simulating, maintaining or applying conditions of speed or load to a vehicle in a safe and controlled environment to data-log and diagnose sensitive problems.


Please note our Dyno is mainly used for development so all Dyno services and power runs must be strictly by appointment only.
To book your dyno test please call: 01132 575338